2000-2006 Chevrolet Tahoe Front Conversion Kit Installation Manual

2000-2006 Chevrolet Tahoe Front Conversion Kit Installation Manual

Take a look at our easy-to-follow 2000-2006 Chevrolet Tahoe Front Conversion Kit Installation Manual to learn how to install your new Strutmasters air suspension conversion kit. Our step-by-step instructions include pictures to help you along the way.

Chevrolet Tahoe parts included in this kit:

  • 2 Gas/Hydraulic Fluid Shocks

Getting Started

  1. Read general service precautions
  2. Wear Eye Protection
  3. Support the vehicle
  4. Remove air suspension parts
  5. Install conversion kit
  6. Disable the ride control light

Tools needed for installation:

  • Metric socket set
  • Floor Jack
  • Jack Stands
  • Metric Wrench Set
  • Wire Cutter/Stripper/Crimping Tool
  • Level Work Surface
  • Spring Compressor (If Applicable)
  • Allen Wrenches
  • Screw Drivers (Phillips and Flat-Head)

Front Electronic Shock Removal InstructionsStep 1

Caution: A sudden release of pressure may cause personal injury or damage to the vehicle. The air suspension system is under pressure until the air supply lines are disconnected. Use the following precautions when servicing the air suspension system: Wear gloves, ear protection, and eye protection. Wrap a clean cloth around the air supply lines. The vehicle must be raised to perform this conversion! Use proper lifting equipment only! Read instructions carefully before attempting installation, if you have problems during the install then feel free to call our Technical Support Line. Please before calling for technical help, have your invoice handy.

  1. Install the new shock absorber. Insert the stem through the hole in the shock bracket on the frame, see Fig 1.
  2. Install the lower shock, mount and bolt.
  3. Tighten all bolts to factory specs.
  4. Reinstall the wheels and safely set vehicle on the ground.

Front Conversion Kit installation complete.

Front Conversion Kit Installation InstructionsStep 2

  1. Install the new shock absorber. Insert the stem through the hole in the shock bracket on the frame, see Fig 1.
  2. Install the lower shock, mount and bolt.
  3. Tighten all bolts to factory specs.
  4. Reinstall the wheels and safely set vehicle on the ground.

Front Conversion Kit installation complete.

Recommended Products