Info and Resources
Learn everything you need to know about this product.
Learn more about what this product does and why you may need it.
Convert Your Air Suspension To A Coil Spring Suspension. End Your Air Suspension Problems Forever...
1984-1992 Lincoln Mark VII 4-Wheel Air Suspension Conversion Kit With Rear Shocks is the perfect solution to your air suspension problems. Designed to be very affordable, you can convert your air suspension to use standard shocks/struts and coil springs for less than the price of replacing one air strut.
Conversion Kit Features
- Saves Money
- All New Components
- Factory New Ride
- More Reliable Than Air Suspensions
- No Modifications Required To Install
- Easy To Install
- Premium Eibach Springs
Air Suspension Conversion Kit Includes
- 2 Front Eibach Springs
- 2 Rear Shocks
- 2 Rear Eibach Springs
- All Necessary Mounts
- All Necessary Hardware
- Detailed Instructions
This Conversion Kit Fits
1984 Lincoln Mark VII, 1985 Lincoln Mark VII, 1986 Lincoln Mark VII, 1987 Lincoln Mark VII, 1988 Lincoln Mark VII, 1989 Lincoln Mark VII, 1990 Lincoln Mark VII, 1991 Lincoln Mark VII, 1992 Lincoln Mark VII
- • If the Rear Shocks Are Worn Out, the Front Struts are Usually Just As Worn Out. Save Time And Money, And Add The Front Struts To Your Order.
How Does Strutmasters Measure Up?
Learn why Strutmasters is the best choice for your new kit.
What kind of suspension does my 1984-1992 Lincoln Mark VII have?The 1984-1992 Lincoln Mark VII is built with the following suspension components:
1984-1992 Lincoln Mark VII Air Springs (x4) - commonly referred to as air bags, a plastic and rubber bag that is fitted on top of the strut that uses pressurized air as a cushion instead of a metal coil spring to hold a vehicle off of the ground and off of its wheels. These are the number one cause of all air suspension leaks. All air springs all go bad at about the same rate. If one is leaking, the others will not be far behind. For a proper repair, all of them need to be replaced at the same time.
1984-1992 Lincoln Mark VII Shock Absorbers (x4) - has metal tubing filled with gas-charged hydraulic fluid that is connected to the wheel of a vehicle in order to reduce the effects of vertical travel on a rough surface which controls the bounciness, and therefore comfort, of a vehicle. Some models dampening may be controlled by the suspension control module and can be very costly to replace.
1984-1992 Lincoln Mark VII Height Sensors (x4) - a linkage located near each wheel of a vehicle with any electronic suspension that, either mechanically or electronically, constantly measures the height of the vehicle, and reports this information back to the control module so that the computer can identify if changes in height need to be adjusted accordingly. The ride height sensor is a moving part, and like all moving parts, they will eventually wear out.
1984-1992 Lincoln Mark VII Air Lines- tubes that run from a compressor to the air which carry pressurized air to the air bags in order to adjust the height of the vehicle, respectively.
1984-1992 Lincoln Mark VII Solenoids (x4) - usually L-shaped, these plastic components connect the electrical connection and lines of suspension components to the suspension control module on vehicles with active suspension. The solenoid regulates the air pressure for each air spring. Solenoids start to leak as they wear out causing the vehicle to sag or to lean. This will cause the ride height sensor to send a signal to activate the compressor in an attempt to inflate the air suspension and level out the vehicle. This excessive work load will eventually lead to total failure of the compressor.
1984-1992 Lincoln Mark VII Compressor Assembly- creates/sends pressurized to active suspension components. When the air suspension starts leaking, the compressor/pump starts working harder to try to keep the system inflated. By the time air suspension leaks down completely, sitting the vehicle on its tires, the compressor will either have failed or be well on its way to full failure. Buying replacement struts and taking the time to install them only to find out the compressor still needs to be replaced can be very frustrating, time-consuming, and expensive.
1984-1992 Lincoln Mark VII Dryer- prevents moisture build-up inside of air suspension parts.
1984-1992 Lincoln Mark VII Suspension Control Module- a computer which is responsible for the operations of the air suspension system and maintaining the vehicle’s correct ride height.
1984-1992 Lincoln Mark VII O-rings- Although they are the least expensive parts of the air suspension, they are responsible for maintaining the seal where all of the air lines connect. Be sure to replace the O-rings when repairing any air suspension system.
How Do I Know If My Air Suspension Is Failing?The most common symptom of a leaking or failed air suspension is a sudden noticeable uneven height difference between different sides of the vehicle. The vehicle could have a sagging rear end or front end, it could lean to the left side or right side, or the entire vehicle could be squatting down lower than normal. Other symptoms could include a suspension warning message or light in the instrument cluster, or the air compressor no longer working or running way too often (which would be very noisy and noticeable). The last major tip is your vehicle is no longer able to reach or maintain the proper ride height.
Why choose the Conversion Kit over replacing the air suspension system on your 1984-1992 Lincoln Mark VII?We have already seen the assortment of parts that construct the air suspension system. Our conversion kit gets rid of having to depend on all of those parts functioning correctly and in sync. This conversion kit consists of (2) new rear shocks with bushings, (4) Eibach coil springs and all necessary mounts and hardware. The conversion not only saves you time and frustration, it saves you lots of money. Now let’s take a look at the cost difference between choosing an air vs. a non-air suspension system. Here, we are going to compare three prices: the price for repairing your air suspension system at the dealer, the price for installing aftermarket air suspension parts on your vehicle, and the price of getting rid of the faulty air ride heartache and installing a brand new coil spring suspension conversion kit:
1984-1992 Lincoln Mark VII OEM Replacement Parts:SOME PARTS UNAVAILABLE!
1984-1992 Lincoln Mark VII Aftermarket Replacement Parts:+ Air Springs ($100/air spring)
+ Rear Gas Shocks ($100)
+ Compressor Assembly w/ Dryer ($220)
= Over $800 (but that doesn’t include replacing electronic components that are known to fail such as the height sensors).
Our 1984-1992 Lincoln Mark VII Conversion Kit:+ (4) Rear Eibach Coil Springs
+ (8) Mounts with hardware
+ (2) Rear shocks with bushings
+ Detailed installation instructions
+ Over-the-phone technical support
+ Limited Lifetime Warranty
= Only $309 (plus s&h).
Choosing the four-wheel air-suspension conversion kit for the 1984-1992 Lincoln Mark VII saves YOU over $400!
5 Great Reasons To Act Now
- Conversion Kits Save You Money
- Limited Lifetime Warranty
- Quick And Easy Installation
- Made In The USA
- Frustration Eliminated Forever!
What Are You Waiting For
Reviews and Videos
Read what customers like you thought of our product.
There are currently no reviews for this product
Watch helpful installation and walkthrough videos.
Ready to Order
Don't wait another minute to get your vehicle running in top condition. Order now to save big!